Electromagnetic flowmeter signal is too weak how to solve

Electromagnetic flowmeters generally operate for a long period of time without maintenance after installation, and require maintenance and routine inspections afterwards. It is normal to receive no signal or the signal is too weak. How to solve it?

1. First make sure that the pipe is full of fluid.

2. If the pipe is too close to the wall, install the probe on the pipe diameter with an inclination angle, instead of installing it on the diameter of the horizontal pipe, use the Z method to install the probe. 3. Carefully select the dense part of the pipe and fully polish the light, apply fully The chelating agent is installed with the probe;

4. Carefully and carefully move each probe near the mounting point to find the maximum signal point to prevent the ultrasonic beam from reflecting the expected area due to fouling of the inner wall of the pipeline or due to local deformation of the pipeline. Installation point

5. The metal pipe with serious fouling on the inner surface of the electromagnetic flowmeter can be used to make the scaling part fall off or crack. However, it should be noted that this method sometimes does not help the ultrasonic waves because of the gap between the scaling and the inner wall. Transmission.