How to accurately determine the fault of the plastic chain of the machine tool

With the rapid development of the machine tool industry, the machine tool accessories industry has continued to rise. At present, it is the prime time for the purchase of plastic towline. Many users buy plastic tow Chains and only use it to understand when to repair and repair plastic towline? Here are four ways to judge the failure of the plastic towline:

1. Test exchange method

That is, in the case of analyzing the general cause of the failure, the maintenance personnel can replace the suspected portion with the spare printed circuit board, integrated circuit chip or component, thereby narrowing the fault range of the plastic towline to the printed circuit board or chip level. .

2, parameter inspection method

When a fault occurs, the system parameters should be checked in time. The parameters are usually stored in the bubble memory or stored in the CMOS RAM to be held by the battery. Once the battery is insufficient or due to external interference, the individual parameters of the plastic towline are lost or changed. Chaos, the machine is not working properly. At this point, the fault can be eliminated by checking and correcting the parameters.

3, visual inspection

It is the first method used by maintenance personnel, that is, when the fault diagnosis is performed, the observation and inspection are performed one by one from the outside to the inside. It is important to note whether there is a missing piece.

4, function detection method

The function program test method is to program the G, M, S, T, F functions of the numerical control system into a functional test program by programming, and store them on the corresponding media, such as paper tape and tape. Run this program during the troubleshooting of the plastic towline to quickly determine the likely cause of the failure.

I hope that everyone pays attention to the daily maintenance and repair of the plastic towline. Maintaining the towline can not only extend the service life of the plastic towline, but also reduce the cost and improve the work efficiency.

We are putting most of our resource and effort into Ratchet Straps and their accessories.

Besides ratchet buckle,straps,what else is missing?

Yes,End Fittings,so here are what we strongly suggest-Single J Hooks.

This is also popular end fitting for ratchet straps,a large parts of ratchet straps are using this-for its universal ability to hook at any holes,anchors.

And yet,you can only get Hooks here or the whole ratchet straps with hooks,galvanized or black coated or even stainless steel,all up to you!

Single J Hooks

Single J Hook Welded,Stainless Steel Single J Hook,Small Single J Hook,Large Single J Hooks

WINNERLIFTING(H.K.)INT'L TRADING LIMITED. , http://www.ratchetstrap.de