Where are feed mixers prone to problems?

One: The grinder does not feed.

The installation equipment will find that it is not expected on the mill. After this period of time, the inlet height of the feeding tube can be adjusted, the high wind spreads, the corn is sucked, it is too low or fed, or the air cannot be fed or fed. Try a few more places to see which is the right place for the fastest feeding. In particular, the three-phase electric crushing motor can be moved forward and backward.

Second: burn the motor.

The motor is the driving force of the entire equipment. Once there is a problem, it will not only affect the production and maintenance costs. Therefore, farmers may wish to use the power box to start the motor to protect the motor. Usually, the wind bag on the surface of the equipment can be scattered to clean the dust on the machine. Keep dry cleaning around the machine to prevent the motor bearings from getting into the dust. Especially when the voltage is seriously insufficient, do not use the equipment. When the new corn is crushed every year, the speed of the feed inlet can be appropriately reduced, because the new corn is dry, but the motor is burned compared with the high humidity of the old corn.

Third: poor tolerance.

For vertical feed mixers, the big question is whether the bearings are broken. If the bearings are damaged and squeak or die, they must be replaced. Therefore, every 40 hours our equipment works, we inject butter, and use high temperature resistant butter.

Fourth: The grinder vibrates.

Whether the qualified grinder is broken corn or idling, there is no vibration. Put a glass of water on the paper shredder to work. Normally qualified water is not splashed out of the paper shredder. If there is vibration, one is that it affects the efficiency, the other is that it is unsafe and prone to safety accidents. Once the crusher vibrates, the balancer must be used to correct the crusher rotor. This is the wind disk. There are also some crushers that take a long time, the wind disc on the wind disc is severely worn and uneven, and it will shake at this time, and the baffle or wind disc needs to be replaced.

Fifth: The dragon blades are worn and the shaft is broken.

Vertical feed mixers have been used for a long time. Some dragon leaves in the mixing tank are severely worn and even lack lumps. Sometimes the vertical axis breaks inside.

Feicheng Animal Farming and Animal Husbandry Machinery Co., Ltd. specializes in agricultural and animal husbandry machinery, environmental protection machinery, comprehensive waste treatment equipment, etc., please call 13562881107