Thermal oil pump structural advantages

The thermal oil pump is the second generation product developed on the basis of digesting and absorbing foreign oil pumps. The basic structure is a single-stage single suction cantilever type foot support structure. The pump inlet is axially inhaled, the outlet is vertically upward, and the motor is installed in the same direction. On the base. The support of the heat-conducting oil pump adopts the structure of the double-end ball bearing support. The front end is lubricated with lubricating oil. The rear end is lubricated with grease. There is an oil guide tube in the middle to observe the sealing condition and recover the heat-conducting oil at any time.

The thermal oil pump adopts a self-heating and heat-dissipating structure, which changes the traditional water cooling structure, so that the structure is simple, the volume is small, the operating cost is saved, the performance is good, and the use is reliable.

(1) Adopt the combination of packing seal and mechanical seal. Filler seal with high temperature resistant filler has good thermal adaptability. Mechanical seal adopts high mechanical strength and good wear resistance of hard alloy material. Sealing properties at high temperatures.

(2) The third generation of polytetrafluoroethylene (abbreviated as PTFE) is used as the lip seal, which leads to a leap in sealing performance, 25 times higher reliability than rubber seals, and extremely high corrosion resistance.