![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
The heat sink is a critical component for a small blasting equipment transporter . As a dedicated vehicle for transporting blasting equipment, it is very important to always check whether the heat sink is operating properly. Only in this way can some potential safety hazards be discovered in the first place. Once a problem arises in heat dissipation, the blasting equipment transporter is very dangerous during driving, and the consequences are unthinkable. Then look at the heat of the small blasting equipment transport vehicle immediately below. Some repair methods of the device!
For the small blasting equipment transporter , the first one that needs to be inspected frequently is the radiator hose. This radiator hose is an important channel of the cooling cycle, but the hose is prone to aging or hardening after prolonged use. In severe cases, damage may occur directly. So for this kind of situation, you can cut the damaged end first and then plug it back in to solve the problem. However, if the hose is only partially cracked and the problem is not particularly serious, it can be sealed by applying some soap liquid directly to the crevices of the hose. The key is to prevent leakage of coolant.
The second thing to check is the heat sink. Once the heat sink is damaged, it will leak. The best emergency method at this time is to choose to pour the tobacco shreds into the cooling liquid outlet of the radiator, and the shreds will block the leaking place along with the circulation of the liquid. When the leaking place is relatively small, it is also possible to block the leakage of the coolant directly with soap. Or after the leak is wiped clean, the rosin is melted and then coated in the leaking coolant. This blockage effect is relatively long-lasting.
The above is the two aspects that the heat dissipation device of the small-scale blasting equipment transportation vehicle often needs to be repaired. It is very necessary to regularly inspect the heat dissipation device, and the rider can use the above method to solve the problem when a similar fault is encountered.
Light Girder Suspension Crane
Maximum load: 2000kg
Used to transfer materials overhead, our Light Girder Suspension Crane is especially suitable for use in workshop that have low ceilings as well as factories and sites made of lightweight steel frames where the bridge crane reaches its limit.
The modular design contains fewer standard parts that make crane assembly as easy as stacking blocks. With these modular parts, users can reassemble a new crane, according to the change in lifting requirements of the alterations made to the workshop.
Due to the ultra-light weight of the crane, there is little friction between the trolley wheel and the rail. Easily moved by hands, this suspension crane can move clumsy, heavyweight workpiece in a fast manner. Available also with the mechanical electrical chain hoist, hoist drive, electrical control device, and matched system, the crane requires limited maintenance and has a long service life.
This series of crane can run on both straight and curved rails. By using many other modular parts, it can be reassembled to become the single-girder or double-girder crane. Each of the modular parts is bored to the standard connector for its size. So the crane can be adjusted according to the layout of the worksite, in order to suit the specific material handling requirement and satisfy customer specific needs.
Optional Parts
Aluminum rail
Railway turnout
Elevating platform
Power supply device
Electrical travel drive system
Light Crane,Flexible Combined Crane,Light Combined Crane,Light Duty Overhead Bridge
Eurocrane (China) Co., Ltd. , https://www.eurocranegroup.com