Grouting pump failure solution

Grouting pump failure solution

During the use of the grouting pump, certain conditions will surely occur. If some faults can be found in time and corrected in time, it will have a very positive effect both on the life cycle protection of the injection pump and the protection of the use effect. What are the solutions to the problem of pump injection when the pump is in a condition?

Fault 1: The pressure pump is damaged

Cause: The voltage is too high and the pressure is too high.

Fault solution: Replace the pressure pump.

Failure 2: high pressure injection pump can not increase

Cause: The bucket was blocked.

Fault solution: Remove the residue from the barrel, remove the obstructions in the barrel, and loosen the joint at the end of the pump to remove the pump interior and the ball spring.

Fault 3: Loose connection between the drill holder and the fuselage

Reason: The high pressure injection pump will cause the drill to loosen due to body vibration during the operation.

Fault solution: Take out the drill, use the electric drill to remove the internal gear, and lock it.

The failure of the pressure pump, the looseness of the drill holder and the joint of the fuselage, and the inability of the high-pressure injection pump to increase are common failures during the use of the injection pump. With the development of the injection pump, these failures have been well received. Solution. The use of each device must meet some difficulties, but as long as it is corrected in time, it is believed that this will minimize work injuries.

Plasticizer

It is high-performance water reducing agent is 3rd generation high-performance water reducing agent. It has excellent comprehensive index. And it is green and environmental friendly product.

It has excellent dispersing capacity. It is especially appropriate for mortar, wear-resistant floor, self-leveling floor and grouting material.


Features and Benefits:

1. Excellent compatibility with various types of cements.

2. High water reducing rate, low dosage, and low slump loss.

3. Low chloride and alkali content, no corrosion to steel-bar.

4. High stability: no precipitation at low temperature.

5. Environmental friendly and nontoxic.

6.Cement paste fluidity more than 250mm,with a dosage of 0.1%.

7.Short delivery time and good sales-after service.

Application:

1.Used in high performance and high strength concrete with high construction requirements.

2.Used in high slump concrete,ready minxed concrete,and pumping concrete.

3.Used in the concrete of high buildings,hydraulic engineering,transport system,port engineering,and municipal engineering etc.

4.Used in other high-lift concrete for specific building.

Mainly Model:DOP,DOA,DINP and DOTP


Phthalate Plasticizer,Phthalic Acid Esters,Concrete Plasticizer,Drywall Plasticizer

Yucheng Jinhe Industrial Co.,Ltd , https://www.hncarbonblack.com

Posted on